Tukwila Boom Lift Safety Training

Tukwila Boom Lift Safey Training - Boom lifts fall under the type of aerial lifting device or elevated work platform. Most commonly used in warehousing, construction and industry; the boom lift is so versatile that it can be used in almost whichever environment.

Elevated work platforms enable workers to get into work places which would be unreachable otherwise. There is inherent risk in the operation of these devices. Workers who operate them should be trained in the right operating procedures. Preventing accidents is paramount.

Boom Lift Training Programs include the safety aspects involved in boom lift operation. The program is best for those who operate self-propelled elevated work platforms and self-propelled boom supported elevated work platforms. Upon successful completion of the course, Individuals who participated would be issued a certificate by an individual who is certified to confirm finishing a hands-on evaluation.

To be able to help train operators in the safe utilization of elevated work platforms, industry agencies, local and federal regulators, and lift manufacturers all play a part in establishing standards and providing the necessary information. The most important ways to avoid accidents related to the utilization of elevated work platforms are the following: having on safety gear, performing site assessment and inspecting equipment.

Key safety considerations when operating Boom lifts:
Operators have to observe the minimum safe approach distance (or also called MSAD) from power lines. Voltage could arc across the air to find an easy path to ground.

A telescopic boom must be retracted before lowering a work platform to be able to maintain stability when the platform nears the ground.

Individuals working from the Boom lift platform must tie off to be able to ensure their safety. lanyard and safety harness combinations should not be connected to any anchorage other than that provided by the manufacturer, never to other poles or wires. Tying off may or may not be required in scissor lifts, that depends on particular local regulations, employer guidelines or job risks.

Avoid working on a slope which goes beyond the maximum slope rating as specified by the manufacturer. If the slop exceeds requirements, then the equipment should be winched or transported over the slope. A grade could be simply measured by laying a minimum 3-feet long straight edge or board on the slope. After that a carpenter's level could be laid on the straight edge and raising the end until it is level. The per-cent slope is attained by measuring the distance to the ground (the rise) and then dividing the rise by the length of the straight edge. Then multiply by one hundred.

Click to Download the pdf